The Amethyst Vintage uses dual diaphragm capsule and is designed for that classic warm sound we know from the best vintage microphones. It has a little bit wider cardioid polar pattern.

Both The Amethyst models are based on Violet Design original true electrostatic capsules. Large size diaphragms are made of the highest quality 6-micron Mylar film. Using Violet Design original technology the diaphragms are tensioned and adjusted on precisely made brass backplates. The diaphragms are sputtered with the Violet Design special formula gold mixture. It gives them faster impulse transient response without sound coloration or low frequency reduction, and adds the ability to handle louder sound pressure levels. At the end of the manufacturing process each capsule is carefully checked for all parameters and measured in an anechoic chamber for optimum of performance.

Unidirectional cardioid polar pattern reduces ambient studio noise. Both microphone models have minimal proximity effect and are linear over the wide frontal incidence angle. The microphones headgrill is made as acoustic filter of multilayer brass mesh that reduces plosive sounds, breath, pop and wind noises, minimizes internal resonance effects, but keeps high frequencies and sound transparency.

The internal solid state preamplifier of the microphone is based on class-A fully discrete transformerless electronics circuit, built using only the highest quality selected components. The circuit is designed under the highest audio standards and provides linear audio frequency range, high dynamics, low self-noise, and very low audio distortion of all types. The Amethyst requires quality and stable 48 V phantom power.

The Amethyst is ready for direct mounting on the standard microphone stand. Rugged microphone construction and two internal shockmounts, separately for the capsule and for the electronics, effectively reduces stand rumble, outside infrasonic interference and mechanical shocks. The additional external elastic studio shockmount is available as option.

APPLICATIONS:

The Amethyst microphones are designed for recording studio all-around needs, capable of capturing vocals, piano, guitars, drums, percussion, strings, wind and other instruments. The microphones can be successfully used in professional sound reinforcement systems, in broadcast and TV studios, in movie and video industry, project studios and home recording, and many other applications.

Specifications:

    * Transducer type electrostatic
    * Operating principle pressure gradient
    * The diaphragms active diameter 25 mm (1")
    * Frequency range 20 Hz to 20 kHz
    * Polar pattern unidirectional, cardioid
    * Output impedance 50 ohms
    * Rated load impedance 1000 ohms
    * Suggested load impedance > 500 ohms
    * Sensitivity at 1000 Hz into 1000 ohms load 21 mV/Pa
    * S/N Ratio CCIR 468-3 weighted 76 dB
    * S/N Ratio DIN/IEC 651 A-weighted 87 db-A
    * Equivalent noise level DIN/IEC A-weighted 7 dB-A
    * Maximum SPL for 0.5% THD at 1000 ohm load 134 dB
    * Dynamic range of the microphone preamplifier 127 db
    * Phantom powering voltage on pins 2 & 3 of XLR +48 V (+/-4 V)
    * Current consumption < 2 mA
    * Output connector 3-pin XLR male, gold plated contacts
    * Signal polarity positive toward pressure on a diaphragm produces positive polarity voltage on XLR pin #2 relatively to pin #3
    * Dimensions and weight 168 x 63 x 41 mm, 350 grams

OPTIONAL ACCESSORIES:

    * studio shockmount
    * studio pop filters
    * foam wind screens
    * microphone cables

Recommended products list

Customer feedback

Send to friend